THIS PACKAGE COMES WITH ABSOLUTELY NO WARRANTY OF ANY KIND, EITHER EXPRESS OR
IMPLIED, STATUTORY OR OTHERWISE. THE ENTIRE RISK AS TO USE, RESULTS AND
PERFORMANCE OF THE PACKAGE IS ASSUMED BY YOU AND IF THE PACKAGE SHOULD PROVE
TO BE DEFECTIVE, YOU ASSUME THE ENTIRE COST OF ALL NECESSARY SERVICING,
REPAIR OR OTHER REMEDIATION.
UNDER NO CIRCUMSTANCES, CAN THE AUTHOR BE HELD RESPONSIBLE FOR ANY DAMAGE
CAUSED IN ANY USUAL, SPECIAL, OR ACCIDENTAL WAY, ALSO IF THE OWNER OR A THIRD
PARTY HAS BEEN POINTED AT SUCH POSSIBILITIES OF DAMAGE.
This install applies to "Enemy 2 - Missing in Action" © 2013 Anachronia.
This install requires WHDLoad version 17 to be in the path.
These programs can be found in the WHDLoad package.
To install from a different drive than DF0: select installation mode Expert.
The installed program requires 1 MB ChipMem and 1 MB OtherMem.
It can be quit by pressing F10 (key can be changed with Tooltype "QuitKey=").
The game requires an installed A600/A1200/A4000 Kickstart 3.1 image.
The kickstart image must be located in the directory "Devs:Kickstarts" and
must be named "kick40063.A600", "kick40068.A1200" or "kick40068.A4000". The
image can be extracted from a A600/A1200/A4000 with tools like 'GrabKick' or
similar which can be found on aminet.
If the image is of wrong version or altered in any way WHDLoad will quit with
an appropriate message.
Additionally the file "kick40063.A600.RTB", "kick40068.A1200.RTB" or
"kick40068.A4000.RTB" must be installed in the same directory as the kickstart
image. It can be found in the archive "util/boot/skick346.lha" on aminet.
Supported release of the game is version 1.26 which can be downloaded from
the website http://www.anachronia.ch .
The game uses nearly the same executable then the first part of Enemy, so all
fixes from that install are also applied here.
Using the option Custom1=1 you skip the Anachronia intro.
version 1.0 (05.01.2014) done by Wepl:
- initial release
version 1.0.1 (09.01.2014) done by Wepl:
- new icons added made by Irek Kloska, thanks!
version 1.1 (19.02.2014) done by Wepl:
- access fault occuring in later levels fixed (issue #2919), thanks to Irek
for report and test
version 1.2 (05.10.2020) done by Wepl:
- made the install 68000er compatible (issue #4812)
- instruction cache now always enabled
- IOCACHE enabled
If you have problems with this installation please try and get a newer
version of this package from the WHDLoad WWW-Page. If that doesn't help try
some Tooltypes like NOCACHE, NOAUTOVEC, EXPCHIP, NOMMU, PAL or NTSC. If
that also fails, please inform the author via the Bug-Report-Form which
can be accessed on the WHDLoad WWW-Page.
For the full WHDLoad package, other installs and updates refer to: