THIS PACKAGE COMES WITH ABSOLUTELY NO WARRANTY OF ANY KIND, EITHER EXPRESS OR
IMPLIED, STATUTORY OR OTHERWISE. THE ENTIRE RISK AS TO USE, RESULTS AND
PERFORMANCE OF THE PACKAGE IS ASSUMED BY YOU AND IF THE PACKAGE SHOULD PROVE
TO BE DEFECTIVE, YOU ASSUME THE ENTIRE COST OF ALL NECESSARY SERVICING,
REPAIR OR OTHER REMEDIATION.
UNDER NO CIRCUMSTANCES, CAN THE AUTHOR BE HELD RESPONSIBLE FOR ANY DAMAGE
CAUSED IN ANY USUAL, SPECIAL, OR ACCIDENTAL WAY, ALSO IF THE OWNER OR A THIRD
PARTY HAS BEEN POINTED AT SUCH POSSIBILITIES OF DAMAGE.
This install applies to "Flower Power" © 1992 Anarchy.
This install requires WHDLoad and RawDIC to be in the path.
These programs can be found in the WHDLoad package.
To install from a different drive than DF0: select installation mode Expert.
The installed demo requires 0.5 MB ChipMem and 0.5 MB OtherMem
(+0.9 MB for preload).
It can be quit by pressing F10 (key can be changed with Tooltype "QuitKey=").
version 1.1 (18.03.2022) done by StingRay:
- patch redone
- patch is file based now to reduce OS swaps
- memory requirements changed from 1 MB chip to 0.5 MB chip and 0.5 MB fast
- blitter waits added
- all line drawing routines fixed (BLTCON0 settings, byte writes to BLTCON1)
- Bplcon0 color bit fixes (x7)
- illegal copperlist entries fixed (x400)
- copperlist termination fixed
- source code included
- 68000 quitkey support
- new install script
version 1.0 (03.10.2000) done by MiCK:
- initial release
Notes for the V1.1 update:
The patch is now using files to reduce OS swaps. Each track contains
an ID/checksum in the first long so it was not possible to load the
data completely in one go as each track had to be loaded separately.
For this reason I have coded a RawDIC imager which saves all files to
avoid the OS swaps. I also spent quite a bit of time to fix all problems
I found, mainly all line drawing routines had to be corrected as they
used wrong BLTONCON0 settings (harmless) and performed byte writes to
BLTCON1. The patch now also does not required 1 MB chip memory anymore,
it works with 512K/512K and quit on 68000 machines is now possible
If you have problems with this installation please try and get a newer
version of this package from the WHDLoad WWW-Page. If that doesn't help try
some Tooltypes like NOCACHE, NOAUTOVEC, EXPCHIP, NOMMU, PAL or NTSC. If
that also fails, please inform the author via the Bug-Report-Form which
can be accessed on the WHDLoad WWW-Page.
For the full WHDLoad package, other installs and updates refer to: